Service manual

Chery S18D Service Manual

3.5. Remove the left and right fog lamp wiring

harness connectors, remove the front bumper

(the front bumper is connected and fixed with

the fender by clip; do not break the clip during

removal of bumper).

3.6. Remove the two fixing bolts of upper air

intake grille with cross screwdriver to remove

the air intake grille.

3.7. Use plastic screwdriver to pry out the edges

of lower air intake grille to remove it.

Note: the air intake grille can be replace directly

without removing the lower bumper.

4. Installation Procedure

The installation procedures are reverse to those

for removal.

II. Removal, Installation & Maintenance of Rear Bumper

1. Preparations

Tools: cross screwdriver, slotted screwdriver, socket wrench and etc.

Parts: expansion bolt

2. Precautions

2.1. Wear necessary appliance for labor protection to prevent from accidents.

2.2. Try to avoid scratching the painted surface of the bumper when removing it.

3. Removal Procedure

3.1. Open the luggage boot lid and use a cross

screwdriver to loosen off the four fixing

screws on the rear bumper.