Owner`s manual

3. Open the latch and close the T-top.
Check to see
if there are any gaps
showing. Unlatch the T-top and adjust
the sunshade as required.
4. Once the sunshade is installed
properly, you can stick the Velcro@
buttons on the glass for
a proper fit
every time you install the sunshades.
To do this, first remove the T-top with
the sunshade installed and place
it
upside down on a table or bench. Take
care not to scratch the glass.
remove the backing paper
from the
Velcro@ buttons. Push the sunshade
back into place sticking the Velcro@
to the glass,
6. Install the T-top, close the latch and
lock
the T-top, Repeat the above steps
for the passenger-side sunshade.
5. Pull the sunshade back a little and
You can store the sunshades in their
storage
area in the rear of your vehicle.
You can also leave them attached to the
T-tops. The
T-tops can still be removed
and placed in their storage slots when the
sunshades are attached.
91 =-.