Owner`s manual

Features and Controls
2 (Second Gear)
This position gives you more power but
lower fuel economy. You can use
“2” on
hills.
It can help control your speed as
you go down steep mountain roads, but
then you would also want to
use your
brakes off and on.
NOTICE:
Don’t drive in “2” (Second Gear)
for more than
5 miles (8 km), or at
speeds over
55 mph (88 km/h), or
you can damage your transmission.
Use
@I or “D’ as much as possible.
Don’t shift into
“2” unless you
are going slower than
65 mph
( 105 km/h), or you can damage
your engine.
0 1 (First Gear)
This position gives you even more power
(but lower fuel economy) than “2.” You
can use
it on very steep hills, or in deep
snow or mud.
If the selector lever is put i~
“1,” the transmission won’t shift into firsf
gear
until the vehicle is going slowly
enough.
NOTICE:
If your rear wheels can’t rotate, don’t
try to drive. This might happen
if you
were stuck
in very deep sand or mud
or were up against a solid object. You
could damage your transmission.
Also, if you stop when going uphill,
don’t hold your vehicle there with
only the accelerator pedal. This
could overheat and damage the
transmission. Use your brakes or
shift
into “P” (Park) to hold your
vehicle
in position on a hill.
Maximum engine speed
is limited to
protect driveline components from
improper operation.
1
3
5
2
4 R
I Manual Transmission
%e-Speed
:his is your shift pattern. Here’s how to
tperate your transmission:
1 (First Gear) - Press the clutch
pedal and shift into “I.” Then, slowly
let
up on the clutch pedal as you
press the accelerator pedal.
You can shift into “1” when you’re
going less
than 20 mph (32 kdh). If
you’ve come to a complete stop and
it’s hard to shift into
“1,” put the shift
lever
in “Neutral” and let up on the
clutch. Press the clutch pedal back
down. Then shift into
“1.”
... 62