Owner`s manual

T-Top Sunshades
1. Start with the panel marked “DRIVER
FRONT.” Unlatch the driver-side
T-top, raise
it halfway and close the
latch handle.
2. With the top raised and resting on the
center roof rail, slide the flat edge of
the sunshade panel
(with the vinyl
side to the glass) between the glass
and plastic trim, making sure the
edge marked “DRIVER FRONT” is
pointing to the front
of the vehicle.
3. Open the latch and close the T-top.
Check to see
if there are any gaps
showing. Unlatch the T-top and adjust
the sunshade as required.
4. Once the sunshade is installed
properly, you can stick the Velcro@
buttons on the glass for a proper fit
every time you install the sunshades.
To do this, first remove the T-top with
the sunshade installed and place it
upside down on a table or bench.
Tdke care not
to scratch the glass.
-
5. Pull the sunshade back a little and
remove the backing paper from the
Velcro@ buttons. Push the sunshade
back into place sticking the Velcro@
to the glass.
6. Install the T-top, close the latch and
lock the T-top. Repeat the above steps
for the passenger-side sunshade.
85.