Owner's Manual
Playing
the Radio
Finding a Station
PWR-VOL:
Press this knob to turn the system on and
off.
To
increase volume, turn the knob
to
the right.
Turn
it
to
the left to decrease volume. The knob is capable
of
rotating continuously.
RECALL:
Press this button to recall the station being
played. If
you
press the button when the ignition is off,
the clock will show for
a
few seconds.
SCW
Your system
has
a feature called
Speed-Compensated-Volume (SCV). With SCV, your
audio system adjusts automatically to make up for road
and wind noise as you drive. Set the volume at the
desired level. Move the control ring behind the upper
knob to the right to adjust the
SCV.
Then, as you drive,
SCV automatically increases the volume, as necessary,
to overcome noise at any particular speed. The volume
level should always sound the same to you as you drive.
If
you don’t want to use
SCV,
turn the control all the
way down. Each notch on the control ring allows for
more volume compensation at faster vehicle speeds.
AM-FM:
Press
this
button to switch between AM,
FM1
and FM2. The display shows your selection.
TUNE:
Press this knob lightly
so
it extends. Turn it to
choose radio stations. Push the knob back into its stored
position when you’re not using it.
SEEK:
Press the right or left
arrow
to go to the next
higher or lower station. The sound will mute while
seeking.
SCAN:
Press one of
the
SEEK
arrows for two seconds,
and SCAN will appear in the display. Use SCAN to
listen to stations for a few seconds. The radio will
go
to
a station,
stop
for
a
few seconds, then
go
on
to the next
station. Press SEEK again to stop scanning. The sound
will mute while scanning.
PUSHBUTTONS:
The
six
numbered pushbuttons let
you return
to
your favorite stations. You can set up to
18 stations (six AM, six FM1 and six
FM2).
Just:
1.
Turn the radio on.
2.
Press AM-FM to select the band.
3.
Tune in the desired station.
4.
Press AUTO TONE to select the equalization that
best suits the type of station selected.
3-10