Owner`s manual

yellowblue
2-30
Headlamp High/Low Beam Changer
First, you must have the
headlamps on. For high
beams, push the turn signal
lever away from you. When
the high beams are on, this
light on the instrument
panel also will be on.
It will go off when you switch to the low beams. To
switch back to low beams, pull the lever toward you.
Flash-to-Pass
With the lever in the low-beam position, pull the lever
toward you to momentarily switch to high beams (to
signal that you are going to pass). If you have the
headlamps on when you release the lever, they will
return to the low beams.
Windshield Wiper/Washer Lever
The lever on the right side
of the steering column
controls the windshield
wipers and washer.
Move the lever to the position you want:
OFF: The wipers are off.
INT: This position provides intermittent windshield
wiper operation. In light rain or snow, you might want to
use this position rather than continuous wiping. You can
change the time between wipes by turning the INT
TIME band. Turn the band forward or rearward for a
longer or shorter delay intervals.
LO: The wipers will run continuously at low speed.
HI: The wipers will run continuously at high speed.