Get To Know Manual

11
Setting Cruise Control
1. Move the lever to .
2. Accelerate to your cruising speed.
3. Press the button and release it.
4. Remove your foot from the accelera-
tor pedal.
5. The CRUISE light will illuminate.
Adjusting/Canceling Cruise Control
To Resume to the Set Speed after
Braking:
Move the lever to the
+
position.
To Increase the Set Speed: Move or
hold the lever to the
+
position, or use
the accelerator pedal to get to a higher
speed and push the button.
To Decrease the Set Speed: Push or
hold .
To Deactivate the Set Speed: Press the
brake pedal. The system will remain on.
To Turn Off Cruise Control: Move the
lever to .
See Section 3 of your Owner Manual.
Windshield Wipers
The windshield wiper functions are locat-
ed on the turn signal/multifunction lever.
(Mist): For a single wipe, twist the
band down to this position and release.
For additional wipes, hold the band at
this position.
(Off): Twist the band to this position
to turn off the wipers.
Delay: Twist the band up to set the
delay time between wipes (the top of the
band equals a shorter delay).
(Low): Twist the band up to this
position for steady wiping at low speed.
(High): Twist the band up to this
position for rapid wiping at high speed.
Windshield Washer
(Washer): To spray washer fluid,
turn the paddle at the top of the turn sig-
nal/multifunction lever toward the wind-
shield and release. There will be a slight
delay before the wipers are activated.
This is normal and allows the washer to
clean the entire windshield.
See Section 3 of your Owner Manual.