Get To Know Manual

Exterior Lamp Control Switch
The exterior lamp control switch, used to
operate the exterior lamps, is located on
the left side of the instrument panel. The
switch can be rotated to each of the fol-
lowing four positions:
(Defeat): Turns off the Daytime
Running Lamps.
(Daytime Running Lamps): Turns
on the parking lamps and the instrument
panel lights only.
(Parking Lamps): Turns on the
parking lamps, taillamps, instrument
panel lights and license plate lamps. If
active, the Daytime Running Lamps will
turn off.
(Headlamps): Turns on the head-
lamps and parking lamps. If active, the
Daytime Running Lamps will turn off.
• To switch the headlamps from low
beam to high beam, pull the turn
signal/multifunction lever toward
you until it clicks and release it.
9
Exterior Lamps
• To use the flash-to-pass feature
(which momentarily turns on the high-
beam headlamps, even if the head-
lamps are off), pull the turn signal/
multifunction lever slightly toward
you, but not so far that it clicks.
Release the lever to turn off the
high-beam headlamps.
Daytime Running Lamps
Daytime Running Lamps (DRL) can
make it easier for others to see the front
of your vehicle during the day. When the
DRLs are on, only the parking lamps
and instrument panel lights will be on.
The DRL system will come on when the
ignition is on, the vehicle is shifted out
of Park and the exterior lamp control
switch is in the (DRL) position.
To Turn Off the DRLs: Turn the exterior
lamp control switch to the (Defeat)
position.
See Section 3 of your Owner Manual.