2009 Express Automobile Owner's Manual

3. Pull the pin handle up to disengage the pin from

the retaining clip, then pull the pin out.

4. Repeat this procedure for the other pins.

5. Pull the seat rearward about 2 inches (5 cm) and

then lift the seat from the ﬂoor rails.

6. Remove the seat from the vehicle.

7. For the ﬁrst row rear

seat, stow the safety

belt latch by attaching

the clip on the safety

belt latch to the trim just

inside the side door.

For the remaining rear seats, stow the safety belt

latch plate on the clip at the window trim.

Replacing the Rear Seats

{ CAUTION:

A seat that is not locked into place properly can

move around in a collision or sudden stop. People

in the vehicle could be injured. Be sure to lock the

seat into place properly when installing it.

{ CAUTION:

A safety belt that is improperly routed, not properly

attached, or twisted will not provide the protection

needed in a crash. The person wearing the belt

could be seriously injured. After raising the rear

seatback, always check to be sure that the safety

belts are properly routed and attached, and are

not twisted.

1. Position the seat into the open slots in both rails.

Push the seat forward in the rail, hooking both

seat bases onto the pins inside of the rails.

1-7