User guide

StabiliTrak Off
In this mode, both stability control and part of the traction
control system are disabled. The vehicle will still have
brake-traction control, but will not be able to use the
engine speed management system. System noises may
be heard as a result of the brake-traction control coming
on. If the controller detects excessive wheel spin in this
mode, the StabiliTrak indicator light may blink and the
STABILITRAK ACTIVE message may be displayed
to warn the driver that damage may occur to the
transfer case.
It is recommended to leave the system on for normal
driving conditions, but it may be necessary to turn the
system off if the vehicle is stuck in sand, mud, ice or
snow, and you may want to “rock” the vehicle in an
attempt to free it. It may also be necessary to turn off the
system when driving in extreme off-road conditions where
high wheel spin is required. See If Your Vehicle is Stuck
in Sand, Mud, Ice, or Snow on page 4-32 for more
information.
When the transfer case is in 4LO, the stability system is
automatically disabled. The StabiliTrak light will come
on and the STABILITRAK OFF message will appear on
the DIC. The StabiliTrak system cannot be turned on
until the vehicle is switched to 2HI, 4HI, or 4AWD.
The following chart describes the StabiliTrak system
events and the corresponding messages and lights that
will be displayed on the instrument panel cluster.
Vehicles with a DIC Vehicles without a DIC Event
StabiliTrak
Indicator Light
DIC Message
StabiliTrak
Indicator Light
StabiliTrak
Service Light
—
Off None Off Off
StabiliTrak On mode (System is fully
enabled, but is not actively
controlling vehicle stability).
Solid
Traction Control
Off
Solid Off Traction Control Off Mode
Solid StabiliTrak Off Solid Off
StabiliTrak Off Mode (StabiliTrak
indicator light will flash when system
first enters this mode).
4-8