Owner's manual

Radio Messages for XM Only
See XM Radio Messages on page 4‑63 later in this
section for further detail.
Playing a CD(s)
Loading a CD(s)
The CD player can hold up to six CDs. As each CD is
inserted, CDP will appear on the display and as each
CD is loading. File check will appear on the display.
Once playback begins, the track and track number will
appear on the display.
If the ignition or radio is turned off with a CD in the
player, it will stay in the player. When a CD is in the
player and the ignition is in the ON/RUN position, the
radio must be turned on before the CD will start playing.
When the ignition and radio are turned on, the CD will
start playing where it stopped, if it was the last selected
audio source.
The CD player can play the smaller 8 cm (3 in) single
CDs with an adapter ring. Full-size CDs and the smaller
CDs are loaded in the same manner.
To load a single CD into the CD player:
1. Press the LOAD button, a message to select a slot
number from 1 to 6 appears.
2. Press the desired slot number. Wait for the
message to insert the disc.
3. Load a CD. Insert the CD partway into the slot,
label side up. The player will pull the CD in.
To insert multiple CDs:
1. Press and hold the LOAD button for two seconds.
A beep sounds and a message to load multiple
discs appears.
2. Follow the displayed instruction on when to insert
the discs. The CD player takes up to six CDs.
3. Press the LOAD button again to cancel loading
more CDs.
4-57