Supplementary Manual

Black plate (16,1)
Acadia, Acadia Denali, Enclave, and Traverse Navigation System (Includes
Mex) - 2012
16 Infotainment System
XM (if equipped) lists also contain a
category to select and the stations
or channels that pertain to the
category. For XM, select the left and
right arrow screen buttons to
change categories. The station
information displays. See “Radio
Menu” in this section to add and
remove XM categories from the
category list. When listening to XM
stations, all of the categories can be
selected when using the right and
left arrow screen buttons on the
main audio screen. Categories
cannot be selected from the
category list screen when they have
been removed.
FM lists may contain a category to
select if stations in the area support
Radio Data Systems (RDS).
2 Refresh List: Select this screen
button to refresh the list of stations.
When viewing a map screen the
name of the station or channel
displays in the top center tab.
¨ SEEK / © SEEK: To seek
stations, press the right or left
arrows to go to the next or previous
station.
This function is also available on
the steering wheel controls. See
“Steering Wheel Controls” in the
index of the vehicle's owner manual
for more information.
To scan stations, press and
hold either arrow for more than
two seconds. The radio goes to a
station, plays for a few seconds,
then goes on to the next station. To
stop scanning, press either arrow
again.
Storing Radio Station Presets
This feature allows up to 30 preset
stations (six FAV pages) to be
stored. You can mix AM, FM, and
XM (if equipped). To store presets:
1. Press
O to turn the system on.
2. If viewing a map screen, press
the source screen button, press
the AUDIO or FAV (favorite)
button. The number of presets is
determined by your selection of
how many FAV pages you have
selected. See more information
on “Number of Preset Pages” in
this section.
3. Select the band.
4. Seek, scan, or tune to the
desired station.
5. Press and hold one of the preset
screen buttons for more than
two seconds or until a beep is
heard.
6. Repeat the steps for each
preset.