Supplementary Manual

Black plate (29,1)
Acadia, Acadia Denali, Enclave, and Traverse Navigation System (Includes
Mex) - 2012
Infotainment System 29
Monitor: From the DVD Setup
screen, press to adjust the aspect
ratio of the DVD on the navigation
screen. This is not available on all
DVDs. This button is not available
for DVD audio.
Press
e to close the screen in from
the left and right sides.
Press
J to fill the screen on the
left and right sides.
Press
d to fill the screen on the
top and bottom.
SEEK
¨ (Next Track/Chapter):
Press to go to the next track or
chapter if the time elapsed is
greater than 10 seconds. This
button may not work when the DVD
is playing the copyright information
or the previews.
© SEEK (Previous Track/Chapter):
1. Press to return to the start of the
current track or chapter.
2. Press again to go to the
previous track or chapter. This
button may not work when the
DVD is playing the copyright
information or the previews.
f (Tuning Knob):
1. Turn counterclockwise one notch
to go to the start of the current
chapter/track, turn it again to go
to the previous chapter/track.
2. Turn clockwise to go to the next
chapter/track.
Fading With a Bose
®
Surround
Sound System (If Equipped)
If the Rear Seat Audio (RSA) is
turned on, the radio disables fade
and mutes the rear speakers.
The following methods allow for
switching surround sound into a
2 channel stereo mode:
.
Select a stereo or 2 channel
mode using the DVD-Video top
menu. Most commercial
DVD-Video top menus contain
audio configuration settings.
.
While the movie is playing,
select Options to show all
available DVD options, then
press the Audio screen button to
switch between the multiple
audio sources on the DVD.
.
Fade the radio two steps to the
rear. When returning to the
center area, the surround track
will turn on again if it was on
before the rear speakers were
faded.
Press AUDIO to change current
DVD audio track.
Some DVD-Video discs only contain
Dolby Digital 5.1 (AC-3) or DTS 5.1
audio tracks and may not allow
conversions into stereo modes.
CD/DVD Messages
If Disc Read Error displays and/or
the CD/DVD comes out, it could be
for one of the following reasons:
.
A disc was inserted with an
invalid or unknown format.
.
The map CD/DVD disc is not
from a correct region.