User Guide

To remove the
underbody-mounted spare,
insert the chisel end of the
wheel wrench,
on an angle,
into the hole
in the rear
bumper. Be sure the chisel
end
of the wheel wrench
connects into the hoist shaft.
Turn the wheel wrench to the left to lower the spare tire.
Keep turning the wheel wrench until the spare tire can
be pulled
out from under the vehicle.
When the tire
has been completely lowered, tilt the
retainer
at the end of the cable and pull it through the
wheel opening.
Pull the tire out from under the vehicle.
I NOTICE:
- ~~
To help avoid vehicle damage, do not drive the
vehicle before the cable
is properly stored.
If you have an inside-mounted spare tire, the tire must
be removed
in order to have access to the jack storage.
10 remove an inside-mounted spare tire, reach into your
tire’s cover and unscrew the wing nut at the center
of the
wheel. Remove
it and the retainer. Unhook the tire from
the mounting bracket and remove the cover.
To remove a rear-mounted spare tire, first make sure
that the carrier arm is fully-latched
to the endgate. Then
remove the spare tire cover.
5-23