Technical data

316 Vehicle care
License plate lamp
2204081
1. Remove two screws and the
lamp cover.
2. To remove the bulb holder
from the lamp housing, rotate
the bulb holder
counterclockwise.
3. Pull the bulb out from the bulb
holder.
4. Replace the bulb.
5. Install the bulb holder into the
lamp housing by rotating the
bulb holder clockwise.
6. Replace the lamp covers.
Interior lamps
Courtesy lamps
1. To remove it, prise the opposite
side of the lamp switch using a
flat-blade screwdriver.
(Be careful not to make
scratches.)
2. Remove the bulb.
3. Replace the bulb.
4. Reinstall the lamp assembly.
Electrical system
Fuses
Data on the replacement fuse must
match the data on the defective fuse.
In a box above the positive terminal
of the battery are some main fuses. If
necessary have them changed by a
repairer.
Before replacing a fuse, turn off the
respective switch and the ignition.
A blown fuse can be recognised by
its melted wire. Do not replace the
fuse until the cause of the fault has
been remedied.
Some functions are protected by
several fuses.
Fuses may also be inserted without
existence of a function.
Note
Not all fuse box descriptions in this
manual may apply to your vehicle.