Technical data

332 Vehicle care
The compressor will inject
sealant and air into the tyre.
The pressure gauge (1) will
initially show a high pressure
while the compressor pushes the
sealant into the tyre. Once the
sealant is completely dispersed
into the tyre, the pressure will
quickly drop and start to rise
again as the tyre inflates with air
only.
10. Inflate the tyre to the
recommended inflation pressure
using the pressure gauge (1).
The recommended inflation
pressure can be found on the
Tyre and Loading Information
label.
The pressure gauge (1) may read
higher than the actual tyre
pressure while the compressor is
on. Turn the compressor off to
get an accurate pressure
reading. The compressor may be
turned on/off until the correct
pressure is reached.
11. Press the on/off button (4) to turn
the tyre sealant and compressor
kit off.
The tyre is not sealed and will
continue to leak air until the
vehicle is driven and the sealant
is distributed in the tyre,
therefore, Steps 12 through 18
must be done immediately after
Step 11.
Be careful while handling the tyre
sealant and compressor kit as it
could be warm after usage.
12. Unplug the power plug (8) from
the accessory power outlet in the
vehicle.
13. Turn the sealant/air hose (7)
counterclockwise to remove it
from the tyre valve stem.
14. Replace the tyre valve stem cap.
15. Replace the sealant/air hose (7),
and the power plug (8) back in
their original location.
2360199
Caution
If the recommended pressure
cannot be reached after
approximately 25 minutes, the
vehicle should not be driven
farther. The tyre is too severely
damaged and the tyre sealant and
compressor kit cannot inflate the
tyre. Remove the power plug from
the accessory power outlet and
unscrew the inflating hose from the
tyre valve.