User's Manual

Instruction Manual, LA322 Lever Action, FEB2016 Pag. 10
Finger position when levering
Put the fingers (we suggest middle, ring
and little fingers) in the loading lever loop.
IMPORTANT: the forefinger must be
always kept out of the triggerguard and
away from the trigger not to risk an
accidental discharge.
The thumb should be kept outward far
Close the lever also with firm and smooth
action.
During this phase, the breech bolt has
cocked the hammer.
Hammer in safety position
Hammer in safety position is strictly recommended when firing is not imminent and cartridge is
chambered.
Hammer is at full cocked position when the action is cycled using the lever, now you can put in
safety position. Place your thumb on the hammer and firmly hold it. While holding the hammer
back, apply just enough pressure on the trigger to release it and gently lower the hammer.
When the hammer is resting on the firing pin pull it slightly rearward until you hear the half cock
click. This is the original safety position, if you pull the trigger, the hammer will not be released.
To start shooting you have to pull the hammer back to the full cock position.
Now you’re ready to shoot.
Rear sight adjustment