User's Guide

www.chiappafirearms.com - 14 - e-mail [e-mail]
close the frizzen.
• Then cock the hammer in fire position and shoot.
• After every shot before start a new loading wait a few moments so eventual powder
residual in the barrel can definitely extinguish.
• Before start a new loading it’s adiveable to put the rod into the barrel so you can check
the barrel is completely free of obstruction.
• ALWAYS pay attention to keep away from your body the muzzle of the gun during
powder introduction.
“STECHER” System:
Some of our firearms have a particular shooting system called “STECHER”.
This can be DOUBLE trigger or SINGLE trigger.
First, cock the back trigger that sets a spring, for the “single trigger stecher” the cock is pushing
forward the trigger, in this way you charge a spring that will click with light pressure when
you’ll decide to pull the trigger.
In both versions there is a screw that allows to adjust the trigger pull.
Always adjust this screw with the gun unloaded.
Disassembling and cleaning :
Military Rifle:
a. Remove the rod.
b. Remove the bands that wrap the stock and the barrel. There are two style bands, with and
without screw. For the screw style, unscrew the screw; for the bands without screw push
the spring so the band can pass over.
c. Unscrew and remove the tang screw.
d. To prevent damage to the stock, turn the rifle up side down and softly hit on a smooth
surface with the muzzle of the barrel (see fig.4). In this way you can easily disassemble
the barrel from the stock.
Fig 3
A
TTENTION:
DO NOT
ADJUST THE
TRIGGER TOO
LIGHT
Stecher Spring
Hammer
Set Trigger regulation Screw