Manual
RHINOUser’sManual
Page 15
PROPER
TWO-HANDS GRIP
Point muzzle in a safe direction.
Load revolver as previously directed.
Grip the frame firmly.
Place index finger on trigger, take aim and gently squeeze rearward until hammer is
released and falls forward striking the firing pin. Be prepared for loud noise and recoil.
Continue procedure until cylinder is empty.
If all rounds have not been fired and you wish to stop shooting, follow procedures for
unloading previously described.
Always use the proper two-hand hold grip. This keeps hands and fingers away from
the barrel/cylinder gap.
Never allow hands or fingers to extend beyond the front of the cylinder when firing. This is
an improper hold for any revolver.
VERY IMPORTANT: GRIP INSTRUCTIONS
WRONG GRIP
Always make sure that you keep your hands and fingers
away from the cylinder and the gap between cylinder and
frame. In particular, your fingers should never be in front
of the cylinder chambers as the gas escaping from the gap
between barrel and cylinder could hurt your fingers.