Operation Manual

14
Instructions
SCAN mode setting
There are five scan modes for selection: A-SCAN, F-CH01, F-CH02, F-CH03 and F-CH04.
Mode
A-SCAN
F-CH01
F-CH02
F-CH03
F-CH04
Function
The microphone will automatically
operate radio scanning to find and
locate a group of clear, interference-
free channels after entering A-SCAN
page and holding SET button.
There are four modes for selection.
Each mode includes several working
channels which are different from
those in any other mode.
When to choose
◼
First-time operation.
◼
Obvious environmental
interference exists / happens.
◼
Only one DWR-5420 system (two
transmitters) in the room.
◼
Two DWR-5420 systems (four
transmitters) to operate
simutaneously in the same room.
◼
One system operates on F-CH01
and F-CH02 modes and the other
system on F-CH03 and F-CH04.
Auto freq hopping
Yes
Yes
1 Use MENU button to go to the SCAN mode page.

2 Press and hold SET button until the scan mode flashes to denote readiness for setting.

3 Press SET or MENU button to select a scan mode between A-SCAN, F-CH01, F-CH02, F-
CH03 and F-CH04. 6 seconds after selecting a scan mode, it will be automatically saved
and the mode will not change after reboot until the setting is changed again.

4 Without any button pressed, the transmitter will operate scanning and then change to A-
SCAN mode.