User manual

-18-
Battery installation
This microphone requires 2 AA-size batteries to operate. Please insert the batteries
according to the correct polarity. Many batteries are known to have leakage problem of
conductive and corrosive liquid. Please observe the rule to remove the batteries if they are
not to be used for a longer period.
Channel setting (SM-1016) and sensitivity setting
Use the attached small screw driver to set the channel and the channel number will show
on the window above it.
Gain control is an adjustable design that enables user to set different output levels. GT is
for the use of instrument with high impedance, such as guitar while MT is for the use of low
impedance such as lavalier or headset microphone. To adjust the audio input levels, simply
use a small screw driver to rotate to a desired level.
Other settings(SM-5016)
1.Channel setting
Use UP or DOWN button to go to the CHANNEL/ FREQUENCY page.
The cursor will ash to allow changes to be made. Pressing UP or DOWN button will
increase or decrease the channel number. The corresponding frequency will change
accordingly. When a desired channel is selected, it will be automatically saved and stored
in the memory.
2. Making changes to Battery selection
Use UP or DOWN button to go to the Battery selection page.
Press UP or DOWN button to move the cursor to either NiMH (rechargeable battery) or
AKLN (Alkaline battery) position.
When the desired battery has been selected, it will be automatically saved and stored in
the memory.
Remark : NiMH battery must be selected when rechargeable battery is being used. Never
select AKLN (Alkaline) when transmitter is intended for charging as Alkaline battery can not
be charged ! Wrong selection of battery will result in
battery sensing electronics to display wrong and misleading status information.