User's Manual

1. Hardware Installation

1-1.Installing a Mouse with Mouse Port (PS/2) Connector

If you have a mouse with a round mouse port connector, you must turn off

the computer before connecting or disconnecting your mouse.

1-2.Installing a USB Mouse

When you use a mouse with USB connector , you don’ t have to shut off the computer. Just plug the USB

connector into the USB port

1-3.Installing a Combo (USB→PS/2)Mouse

The Combo Mouse comes with a USB connector, together with

a USB→PS/2 port adapter.

Before plug your mouse into the computer, try to make sure what kind of

mouse port you have. If you have a USB port, plug in the original USB

connector; if you have a PS/2 port, please connect the adapter

first to the cable, then plug into the PS/2 port.

1-4.Select a Suitable Channel

First, check how many channels of the mouse on the package or the channel

switch. Choose and switch 1 or 2 channel on the back of mouse and receiver. There will be some interfere

when your nearby classmates or colleagues and you are using the same channel. Change to the other channel

immediately when it happened. If your mouse is only one-channel type, just skip this section.

1-5.Select and Set ID

1-5-1.Before setting ID, you have to select a suitable channel first.

Plug in receiver connector to your computer to turn on LED indicator.

After pressing ID setting button on the back of receiver, the LED

lighting flashed, and it's ready for your further mouse ID setting:

1-5-2.Select one of four mouse ID setting ways:

1)ID one: Press the ID defining button (on the back of mouse)

2)ID two: Press command key (usually the left button) first, then ID defining button. Release ID

defining button first, then command key.

3)ID three: Press pup-up key (usually the right button) first, then ID defining button. Release ID

defining button first, then pup-up key.