Mouse User's Manual 1994-1998 Copyright All Rights Reserved FCC Statement on CLASS B Note: This equipment has been tested and found to comply with the limits for a CLASS B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential installation.
a Serial Mouse You must have a PC fitted with a serial in order to install the mouse. Plug your mouse into the serial port. a Mouse with Mouse Port (PS/2) Connector If you have a mouse with a round mouse port connector, you must turn off the computer before connecting or disconnecting your mouse. a Combo Mouse The Combo Mouse comes with a PS/2 (DIN 6) cable connector, together with a PS/2 -> Serial (OOM 9) port adapter.
Driver for DOS (1) Insert the mouse driver diskette in Drive A (or B). Type the following: A: (2) On the diskette are files required for the correct installation of the software. Type the following : DOS INST Follow the on-screen instructions properly. (3) Driver Software Options The mouse driver has several software options.
Follow the instructions on the screen. Driver for Windows 95, Windows 98 & Windows NT 4.0 To install Mouse Driver for Windows insert the floppy into the drive, click on the Start button, select Run, and type if you insert the Mouse Driver Disk in drive A. or type if you insert the Mouse Driver Disk in drive B. Follow the instructions on the screen. 2-4 Remove the Windows Mouse Driver (1) In the Mouse Driver folder opened on installation, Click the “Uninstall” icon, and follow the instructions on the screen.
(B) If you are running Windows 95 (or NT 4.0) do the following: Select Select Select Select Select Select Select "Start". “Settings”. "Control Panel”. "Mouse" icon. "General". "Change". a new mouse driver that meets your new requirements. The new setting will over-ride the old ones.
Mouse Hardware Modes (None mode switch) As mentioned earlier, the serial mouse is capable of operating either as a Microsoft Serial Mouse or a Mouse Systems Mouse. Which of the two modes the mouse will operate in is determined on the power-on initialization. If any one of the three buttons is depressed during power-on initialization, the mouse will emulate Mouse Systems Mouse. While none of the buttons is depressed during power-on initiation the mouse will emulate Microsoft Mouse. 3-3.
Symptom 2 : Solution Symptom 3 : Solution Symptom 4 : Solution Symptom 5 : Solution The cursor on the screen remains at one spot or moves erratically. : Check the mouse cable for any breaks or sharp twists. Examine the cable closely where it connects to the mouse. The cursor movement stops at a corner and no longer responds to the mouse movement. : Run the mouse driver to check which mode the mouse is operating in.
AUTOMATON TO THE USER FERRET ERR Ek kop This device complies with part 15 of the FCC Rules. Operation ig subject tao the following two conditions: tL} This device may not cause harmful interference, and {2} This device must Accept Any interference received including interference that may cause undesired operatic. NOTE: This equipment has been tested and found to campy with the limits for a Class B digital device.