2.4G Smart Link 2.
Smart Link 2.4G Wireless Optical Mouse a 2004 All Rights Reserved. The copyright is the property of its respective owners. Notice: Federal Communications Commission (FCC) requirements, Part 15 This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Smart Link 2.4G Wireless Optical Mouse 1. Open the cover of battery. 2. Insert the batteries and then close the battery cover. Ÿ Connect the Receiver to Your Computer USB Connector: Plug the connector of the mini receiver into the USB port of the computer. USB Port Ÿ Link the Mouse with the Receiver 1. Turn on the computer. 2. Press the ID Link Button at the mini receiver and the LED indicator will blink. The receiver is ready to automatically link with the mouse. 3.
Smart Link 2.4G Wireless Optical Mouse Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ surfaces. Please avoid using the optical mouse on any reflective, transparent, metallic or complex-pattern surface. Recommendation: please do not use the mouse during charge periods. The LED indicator at the receiver will light while the mouse is low battery. Please recharge or change the batteries immediately. Press any button to wake up the mouse while the mouse is in the sleeping mode. Please avoid using the mice under the following conditions.
Smart Link 2.4G Wireless Optical Mouse the system, attempt the following step(s): 1) Please check the mouse port setting from the computer. 2) If you have a mouse with a mouse port adapter, please connect the mouse to the computer through the mouse port adapter. Restart the computer and check if the mouse is detected properly. 3) If the problem persists, please check for a possible computer BIOS ROM upgrade from your computer manufacturer.
PMU-26600002 / MADE IN CHINA
