User's Manual

2
Smart Link 2.4G Wireless Optical Mouse
1. Open the cover of battery.
2. Insert the batteries and then close the battery cover.
Ÿ Connect the Receiver to Your Computer
USB Connector: Plug the connector of the mini receiver into
the USB port of the computer.
Ÿ Link the Mouse with the Receiver
1. Turn on the computer.
2. Press the ID Link Button at the mini receiver and the LED indicator will
blink. The receiver is ready to automatically link with the mouse.
3. Press the ID Link Button on the back of the mouse. The indicator will turn
off while successfully finish the linkage.
4. The LED indicator will be dark while you move the mouse.
5. If you need to re-link the mouse, please repeat the above linkage step
2~3.
6. If the mouse is interfered by other wireless-mouse users nearby, please
change the Link ID by re-linkage immediately.
7. There are 256 Link IDs.
8. The LED indicator on the receiver will light while the mouse is low battery.
Please change the batteries immediately.
9. Press any button to wake up the mouse while the mouse is in the sleeping
mode.
Charge Mode
Notice:
- Please skip this section if your mouse is not rechargeable.
- There are two charge modes for the rechargeable version. Some mice may
have only one charge modes.
- Please use rechargeable batteries for the chargeable mouse.
- At the first time of usage, please charge the AAA batteries at least 6 to 8
hours.
1. Charge from PC: Connect the mouse to the USB port of the computer with
the USB to DC cable.
2. Charge through Adapter: Connect the mouse with the AC to DC adapter.
Notice
Ÿ This equipment is intended for use in the following countries.
18 European Countries:
Austria, Belgium, Denmark, Finland, France, Germany, Greece, Iceland,
Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden,
Switzerland and United Kingdom
Ÿ Please do not change the frequency, features and functions of wireless mice
from the original design.
Ÿ The optical technology can precisely detect the mouse motion on most
USB Port