Use And Care Manual

15
CBO-1000 Assembly Instructions
Parts and Components
The CBO-1000 Oven Support Base must:
• be constructed of masonry or metal
• have at least the same area dimensions as the
external footprint of the Oven
You must check with your local Building Department to determine
the amount of clearance required by local building codes between
the Oven and Decorative Cover. CBO recommends you add at least
8 inches for the width (4 inches per side) and 5 inches for the depth
(on the back side of the Oven) to accommodate the Decorative
Cover and Insulation. Also see the Requirements for Clearance from
Combustible Materials section on Page 18 of this manual.
CAUTION: DO NOT USE ANY COMBUSTIBLE MATERIALS
IN THE CONSTRUCTION OF THE COVERING (SHROUD) OF
THE OVEN. ALL BUILDING MATERIALS USED NEAR THE
OVEN, METAL ANCHOR PLATE AND FLUE PIPE SHOULD
BE NONCOMBUSTIBLE AND NEVER MADE OF WOOD.
The Support Base surface must be flat, level and strong enough
to support the total combined weight of the Oven (920 lbs.) and
the Decorative Cover design you choose.
The two vertical support feet of the Support Base are typically
made of concrete block. The horizontal Support Base is typically
made of a 4-inch-thick, steel-reinforced concrete slab. The standard
height of the horizontal part of the Support Base is 42 inches.
Note: Imagine the Oven’s Support Base as a table. The table’s
legs are concrete blocks and the tabletop is a 4-inch-thick concrete
slab. To build the Support Base, you build the support legs out
of concrete block, then on top of that leg base, you build a frame
to pour a concrete slab (the tabletop). On the concrete slab (the
tabletop), you position the Sub-hearth Insulation Boards, then the
Hearth, then the Oven.
CAUTION: TO AVOID THE POSSIBILITY OF A FIRE,
NONCOMBUSTIBLE MATERIALS MUST BE USED IN
THE CONSTRUCTION OF THE SUPPORT BASE AND ANY
FRAMING USED AROUND THE OVEN.
Support Base
CBO-1000 OVENS SHOULD BE INSTALLED BY A PROFESSIONAL
OR SUITABLY QUALIFIED INDIVIDUAL.
Insulation Boards Insulating Blankets Mortar14-Gauge
Galvannealed
Steel Plate
Steel Binding
Plate
Oven Accessory:
Brush
Anchor B
ox with DuraTech 8"
Anchor Plate— For UL-Required
Installations (Model #8DT-AP)
Washers & Bol
ts
R
emovable Insulat
ing Door
Dome (2 pieces),
Hearth
(3 pieces) & Arch
ThermoWorks
Thermometer
*
Works with Class A Stainless Steel
DuraTech 8" Double Wall Pipe (model
#8DT-24SS) to meet Standard HT 103.