Operating instructions

SKU 67080 For technical questions, please call 1-800-444-3353. Page 15
Check that nothing is behind the door 7.
which may be in the way of the cut-
ting Blade.
Verify that there are no utility lines or 8.
hardware in or near the workpiece.
General Operating Instructions
Adjust the saw height and cutting 1.
depth as needed.
Make sure the Dust Collector is se-2.
curely attached.
CAUTION! Make sure that all guards are
in place and in proper working order
and that all adjustment knobs, includ-
ing the Flange holding the Blade in
place, are tight before operation.
Make sure the cord is positioned so it 3.
will be clear of the cutting area.
Plug the cord into a grounded circuit.4.
Position the Blade near the non-5.
hinged corner of the door. Depress

Trigger down. Release the Safety

Allow the Saw to come up to full
speed before addressing the work-
piece.
Hold the Saw with both hands and al-6.
low it to cut through the workpiece at
its own pace.
Note: The face of the Base Guard should

and hard surface so that the saw can
easily glide, making a clean cut.
Slow down near the hinge end of the 7.
door so you don’t cut beyond the end
of the door.
When the cut is complete, release the 8.
Trigger. Allow the Saw to coast to a
stop before setting it down.
To prevent accidents, unplug the Saw 9.
after use.
After every use, clean out the Dust 10.
Collector Bag. To clean the Bag:
Unzip the zipper on the Dust Collec-a.
tor Bag and empty any accumulated
debris.
Zip the Bag closed.b.
Clean, then store the Saw indoors out 11.
of children’s reach.