Specifications

Page 18SKU 98839 For technical questions, please call 1-800-444-3353.
Engine maintenance:4.
After rst 5 to 8 hours of use: a. Change oil. Then, change oil every 50 hours
of use. Change oil every 25 hours of use when operating the Engine under a
heavy load or in high temperatures. To change the oil, remove the Plug (59A)
and allow the old oil to drain in a proper container. Once drained, replace the
Plug. If the Engine will be run in temperatures above 32° Fahrenheit, use SAE
10W-30 weight oil. If the Engine will be run in temperatures below 32° Fahr-
enheit, use SAE 5W-30 weight oil. To ll the Engine crankcase with new oil,
unscrew and remove the Oil Dipstick (65A). Pour engine oil into the oil ll hole
until the level of oil is even with the bottom edge of the oil ll hole (if you cannot
see the oil through the oil ll hole, then the oil is too low and more oil must be
added). Make sure to screw the Oil Dipstick (65A) rmly back into its Dipstick
Hole. Also, make sure to dispose of the old oil according to local waste disposal
requirements.(See Figure F.)
AIR FILTER COVER
(18A)
AIR FILTER ELEMENT
(19A)
AIR FILTER SEPARATOR
(20A)
FIGURE G
SPARK PLUG (28A)
SPARK PLUG WIRE (36A)
b. After every 25 hours of use: Service the Air Filter Element (19A) and Air Filter
Separator (20A). To do so, remove the Air Filter Cover (18A). Remove the Air
Filter Element. Immerse the Air Filter Element in a mild solvent and squeeze
the Element several times to clean. Remove the Element from the solvent
FIGURE F
OIL DIPSTICK
(65A)
PLUG
(59A)