Instructions / Assembly

INSTRUCTIONS
Wood and Faux wood blinds
Thank you for your purchase.
If you have any questions on your Chicology blinds you can contact our friendly customer service at
1866-999-6188 (8:00 am - 5:00 pm PST)
Contact Us
You can tilt your blinds by pulling on the tilting cords or by operating the tilting wand.
Operating your blinds
Care and cleaning
Tips :
Before you begin your installation :
Key Parts :
To raise or lower your blind you must pull on the lift cords and lock at the desired height.
Raising or lowering the blinds :
Clock or counter clock wise.
Adjusting slat tilt :
1. Check hardware
Install cord cleat
installation bracket center support bracket screw cord cleat
Make sure your blind has the appropriate hardware and that it came with the right dimensions.
You can maintain your blinds by dusting them with a soft cloth.
Additional instructions apply as follows :
For Stain-Finished Hardwood Blinds :
You can use wood treatment products and a soft cloth to keep your blinds in good condition.
.
For Painted Wood and Faux Wood Blinds :
Simply use a soft cloth to wipe stains and dust off.
Installation bracket
Cord/Tilt wand
Center support bracket(s)
(If included)
Slats
Headrail
Valance
Lift cord
Cloth tape
(Upgrade)
Pressure
Width
Height
Mark the bracket locations - Outside mount
Install the brackets - Inside mount
OR
OR
Install the brackets - Outside mount
Attach the headrail to the mounting brackets
Put the clips on the back of the valance, clip valance on headrail.
Attach side returns to the front piece of the valance with “L” clips provided. Install the cord cleat next to the blind to ensure cord is out of reach of children.
Valance can be rotated for style preferences.
Attach valance
Attach valance - Outside mount
Pull up the cover on the tilt mechanism.
Rotate the wand both ways to make sure it functions properly.
Hook the wand into place, and then pull down the cover.
Attach the tilt wand
Example : Installation in a wood window frame using the included screws.
Use two screws per bracket.
Drill pilot holes using a 1/16” drill bit. Depending on the installation location, box brackets
can be attached using the top, back, or side holes.
Mark the bracket locations - Inside mount
Outside Mount Installation Inside Mount Installation
Snap
2.06
Place the installation brackets on each side of the headrail.
If provided with center support bracket :
If using only one - place in center.
If more than one - space them across the headrail evenly.
Place the installation brackets on each side of the headrail.
If provided with center support bracket :
If using only one - place in center.
If more than one - space them across the headrail evenly.