Instructions / Assembly

INSTALLATION INSTRUCTIONS
Step 1. Check Package Contents
Missing part? Call 1-800-264-1190
Mounting hardware kit includes the
following:
Part Quantity
a. Mounting Brackets 2 shades up to 45” wide
3 up to 72” wide
b. Extension Brackets
(for outside mounts) 2 shades up to 45” wide
3 up to 72” wide
c. Screws 4 shades up to 45” wide
6 up to 72” wide
d. Wall Anchors 4 shades up to 45” wide
6 up to 72” wide
e. Handle for Bottom Rail 1 shades up to 48” wide
2 shades over 48” wide
Step 2. Tools Required
Pencil, tape measure, level, screw driver,
pliers, step stool, drill.
Step 3. Installation
Your blind may be installed either inside
the window frame or outside the window
frame.
Wallboard or Plaster: use wall anchors.
Concrete, Stone, Brick: use a masonry
drill bit and anchors or screws specifically
designed for masonry (not included).
Inside Mounting:
One bracket should be positioned about
2” to 6” from each end of the head rail.
For wider shades that require 3 or 4
brackets, these should be spaced evenly
between the two outermost brackets.
Attach each bracket to the inner top of
the window opening using the screws
provided. Pre-drill the screw holes using a
5/64” drill bit. The extension brackets are
not used for inside mounts.
For flush inside mounts, attach the
brackets to the head rail first (see
drawings and attachment instructions
below), and then position the shade in the
window opening as desired. Then make
pencil marks at the back of each bracket.
Remove the brackets by pressing on the
plastic tab. Align the brackets with the
pencil marks, and then screw them in
place as described above.
Outside Mounting:
Attach the Extension Brackets to the wall
or window framing. One bracket should
be positioned about 2” to 6” from each
end of the head rail. For wider shades that
require 3 or 4 brackets, these should be
spaced evenly between the two outermost
brackets. Pre-drill the screw holes using a
5/64” drill bit.
The brackets must be level – use a Spirit
Level if necessary to assure proper
alignment.
Then attach a Mounting Bracket to each
Extension Bracket using the nut and bolt
pre-attached to each Extension Bracket.
Cordless Zebra Shades
Warranty Remedy: This shall be your sole remedy under this limited warranty. If this
product is found to have a manufacturing defect in materials or workmanship, we will, at
our discretion, do one of the following:
· Repair the product
· Replace the product
· Refund the cost of the product.
Colors may vary from lot to lot and may not exactly match sample swatches or previous
purchases.
Discontinued items or color selections will be replaced with the closest equivalent
current product.
Your rights under state law: This lifetime limited warranty gives you specific legal
rights, and you may have other rights which vary from state to state. Some states do not
allow limitations on how long a warranty lasts, so the above limitations may not apply
to you. No agent, representative, dealer or unauthorized employee has the authority to
increase or alter the obligation of this warranty. This lifetime limited warranty supersedes
any previous versions.
For Outside Mount