Manualshelf

Measurement Guide

ManualsBrandsChicology ManualsBlindsVertical Blind Oxford White PVC Cordless Vertical Blind - 78 in. W x 84 in. L
12
INSIDE MOUNT:
Place a light pencil mark on the front of the
headrail 7 inches
from each end. Hold the
headrail up inside the sliding door
casing and place pencil marks on casing, directly in line with the
headrail marks.
CORDLESS VERTICAL
BLINDS INSTRUCTIONS
1
Check the Hardware
PREPARATION
A
B
C
Head Rail x 1
Wand x 1
Valance
Returns
x 2
Louvers x 25
F
G
Valance
Clips
x 4
E
Valance
Corners
x 2
Wall
Anchors
x 6
J
H
Mounting
Bracket
x 3
Mounting
Screws
x 6
I
2
Prepare Tools
1
Position Blinds
7 in. 7 in.
84-1/2 in.
84-1/2 in.
OUTSIDE MOUNT:
Place a light pencil mark on the front of the headrail
7 inches
in from each end. Hold the headrail up to the sliding door at the
height of the pencil marks on the wall. Center the
headrail over
the top of the sliding door and use the pencil marks on the
headrail to make two more pencil. marks on the wall.
A
A
NOTE: The third or fourth bracket should be evenly
spaced between the two outer brackets.
INSIDE MOUNT:
Remove preassembled metal clip from mounting bracket .
Only the metal clip will be used for the inside mount method.
Align front of the metal clip with the pencil mark. The hole
for theclip most be at least 2 in. away from the sliding door
or wall to allow for full louver rotation. Fasten the metal
clip to the sliding door frame with the mounting screw .
2
Mount Brackets
OUTSIDE MOUNT:
Place mounting brackets at pencil mark and secure in
place with mounting screws
I
F
I
3
Hang Headrail
The headrail is reversible depending on which side
you would like to have the louvers stack and where
you want the wand control. Center the headrail under
the mounting brackets and snap into position.
A
F
B
I
A
H
H
I
I
H
H
H

Summary of content (2 pages)