User's Manual

Table Of Contents

A. FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device,

Pursuant to Part 15 the FCC rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) This device must accept

any interference received, including interference that may cause undesired operation.

WARNING:

Use only shielded cables to connect I/O devices to this equipment.

You are cautioned that changes or modifications not expressly approved by the party responsible

for compliance could void your authority to operate the equipment.

CAUTION: AVOID PROLONGED USE OF THE KEYBOARD WITHOUT BREAKS.

Take regular breaks and keep a good posture. Consult your physician promptly if you notice any

lost of motion or pain in your wrist when using the keyboard.

INFORMATION FOR OPTICAL POINTING DEVICES ONLY :

User-observable light is 15 microwatts in normal operation.

This product has been tested to comply with international Standard IEC 60825-1:(1993), incid.

Amd.2(2001). This product uses LEDs that are inherently Class 1.

Class 1 LED Product

B. PRODUCT SPECIFICATION

1. SYSTEM AND INTERFACE

Receiver Interface: USB interface designed to be fully compatible with Microsoft Windows 98,

ME, 2000, XP system.

2. HOT KEYS

Implements 17 hot keys to easy access as below function: Volume down, Mute, Volume up,

Previous track, Stop, Play, Next track, Wake up, Sleep, Shut down, Internet, Email, Search,

My favorite, Calculator, Backward, and Forward function.

3. FREQUENCY BAND :

Keyboard – 27.195 MHz

Mouse – 27.045 MHz

4. FREQUENCY MODULATION : FSK MODE

PAGE 1
A. FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, Pursuant to Part 15 the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 2
5. POWER RATING : Keyboard: 3 V , 30 mA (MAX)_ Mouse: 3 V , 50 mA (MAX)_ Receiver: 5 V , 100mA (MAX) for USB 6. BATTERY: Keyboard: 2 pieces of AA Batteries Mouse: 2 pieces of AA Batteries 7. BATTERY LIFE TIME : Keyboard: 500 hours reference (operating mode) Mouse: 60 hours reference (operating mode) 8. OPERATION DISTANCE Keyboard: 6 feet without signal disturbance and no direction limit. Mouse: 5 feet without signal disturbance and no direction limit. 9.
PAGE 3
times to release all electrical current inside the device, otherwise the device may be not workable after battery put in." F. HOTKEYS FUNCTION A brief introduction is for the hotkey functionality. 1. Decreasing the volume This key decreases the volume of the connected loudspeakers. 2. Mute Use this key to switch on/off the connected loudspeaker. 3. Increasing the volume This key increases the volume of the connected loudspeakers. 4.