User Manual Wireless Touchpad
Setup: Wireless Touchpad System Requirements The following is a list of system requirements: z One USB port (for the USB Receiver) z Microsoft Windows 8. Contents of the Box Note: NOTE: The USB receiver may be pre‐installed on your computer. Note: Insert documents vary according to shipping country’s requirements.
Setting Up Step 1: Setting up the Wireless Touchpad Step 2: Connect the USB Receiver to Computer If your keyboard and mouse are NOT working, please refer to Troubleshooting page
Features: Wireless Touchpad Front View 1 3 2 1 LED Indicator Indicates the status of Power on and when battery is low. White (solid) – Fade on = 1 sec. On = 10 sec. Fade off = 1 sec. Amber (flashing) – Battery charge is < 15% power.
Back View 1 1. Power switch 2.
Gesture Functions Cursor Moving, Left/Right/Up/Down Tap, Open the App, the function as the mouse left button. Support single and double click. Left Edge swipe, Reveal all the open App, left edge to right side. Right Edge swipe, Reveal start charm Top Edge swipe, Close open App, from top edge to down side Top Edge swipe, Reveal App Menu Slide, left/right, App move as same as the finger move. Zoom in, Zoom out picture/Metro surface/Page and so on.
Rotate, All the supported rotated App, support 90°rotate.
Volume Up Mute On/Off
Specifications: Wireless Touchpad Electrical Operating Voltage 2.0 V to 3.2 V Battery life 3 months and above Battery require 2*AA Alkaline Physical Characteristics Height 23(± 0.4) mm Length 130(± 0.5) mm Width 128(± 0.5).mm Weight 205gw with batteries Environmental Operating temperature 0 °C to 40 °C Storage temperature -40 °C to 65 °C Operating humidity 90% maximum Relative Humidity, non condensing Storage humidity 95% maximum Relative Humidity, non condensing 2.
Troubleshooting: Wireless Touchpad If you have problems with your Touchpad: z Check if the batteries are inserted in the correct orientation. z Check if the Touchpad's power switch is set to on. z Remove and reinstall the batteries. The power status light fades on (solid white) for about 1 second and on 10 seconds and then fades off 1 second. z Remove and insert the USB receiver again. z Restart your computer. Insert the USB receiver into another USB port on your computer.
FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, Pursuant to Part 15 the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
