INSTALLATION INSTRUCTIONS Projector Mount Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutch Product Description French Product Description RPA Series
RPA Series Installation Instructions DISCLAIMER Milestone AV Technologies and its affiliated corporations and subsidiaries (collectively "Milestone"), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product.
Installation Instructions RPA Series LEGEND Tighten Fastener Adjust Apretar elemento de fijación Ajustar Befestigungsteil festziehen Einstellen Apertar fixador Ajustar Serrare il fissaggio Regolare Bevestiging vastdraaien Afstellen Serrez les fixations Ajuster Loosen Fastener Security Wrench Aflojar elemento de fijación Llave de seguridad Befestigungsteil lösen Sicherheitsschlüssel Desapertar fixador Chave de segurança Allentare il fissaggio Chiave di sicurezza Bevestiging losdraai
RPA Series Installation Instructions PREPARATION Locate Mounting Site 1 WARNING: IMPROPER INSTALLATION MAY LEAD TO Threaded extension column (not included) PROJECTOR MOUNT FALLING CAUSING SEVERE PERSONAL INJURY OR DAMAGE TO EQUIPMENT! It is the installers responsibility to make certain the structure to which the projector mount is being mounted is capable of supporting five times the weight of the projector mount and all attached equipment.
Installation Instructions IMPORTANT ! : When RPA is properly positioned, the set screw access hole should be pointing directly at target, or 180° AWAY from target. 4. RPA Series 4. Secure the threaded rods to the RPA with one 1/4-20 jam nut (not included) and one 1/4" washer (not included) on each threaded rod. (See Figure 4) Secure RPA to structure using four 1/4" x 2" minimum length lag bolts (not included) and four 1/4" flat washers (not included).
RPA Series Installation Instructions Installing Projector with Interface Bracket (Mounting structure not shown for clarity) 1. Orient projector with interface bracket. 2. Loosen (but do not remove) thumb nuts on the interface bracket. (See Figure 5) 3. Raise projector with attached interface bracket to RPA projector mount (A). (See Figure 5) 6 5 x4 (Mounting structure not shown for clarity) (A) 5 2 x4 Locating slots 3 Figure 6 7. Figure 5 4.
Installation Instructions RPA Series ADJUSTMENTS 4 The RPA projector mount can be adjusted for pitch (vertical elevation), roll (horizontal tilt), and yaw (rotation). 5 6 x4 WARNING: OVER-LOOSENING OR REMOVAL OF HARDWARE MAY RESULT IN PERSONAL INJURY OR SERIOUS DAMAGE TO EQUIPMENT! RPA projector mount and hardware is to be loosened only enough to allow for necessary movement. 5 Pitch (Vertical Elevation) Adjust pitch using the two pitch adjustment screws located on each end of the RPA. 1.
RPA Series Installation Instructions USA/International Europe Chief, a products division of Milestone AV Technologies 8800-002641 Rev00 2014 Milestone AV Technologies www.chiefmfg.com 09/14 Asia Pacific A P F A P F A 6436 City West Parkway, Eden Prairie, MN 55344 800.582.6480 / 952.225.6000 877.894.6918 / 952.894.6918 Franklinstraat 14, 6003 DK Weert, Netherlands +31 (0) 495 580 852 +31 (0) 495 580 845 Office No.
