Installation Instructions

PACLR2 Installation Instructions

2. Verify latching flag is in the OPEN position. (See Figure 10)

3. Align four mounting buttons on display with four teardrop

mounting holes in accessory.

4. Slide mounting buttons into teardrop mounting holes and

lower display until recessed area of mounting buttons is

seated in lower area of teardrop mounting holes.

WARNING: IMPROPER INSTALLATION CAN LEAD TO

DISPLAY FALLING CAUSING SEVERE PERSONAL

INJURY OR DAMAGE TO EQUIPMENT. Make sure ALL

mounting buttons are properly seated in lower area of four

teardrop mounting holes.

5. Move latching flag to CLOSED position to secure display on

accessory. (See Figure 10)

NOTE: A padlock or similar device can be used to provide

additional security.

6. Install speaker mounting brackets with speakers to speaker

mounting rails by using four button head cap screws and

four washers set aside earlier. (See Figure 11)

Figure 10

Figure 11

7. Adjust speaker horizontal location. (See Figure 12)

8. Tighten eight button head cap screws to hold speaker

mounting rail in place. (See Figure 12)

Figure 12

9. Route all signal and power cables and wires to display and

speakers.

Display

Latching Flag

OPEN

Speaker Mounting

Bracket

(1each end)

Speaker not shown for clarity

Front