INSTALLATION INSTRUCTIONS Security SLM Series Mount RPMA1, -B1, -C1
RPMA1, -B1, -C1 Installation Instructions DISCLAIMER CSAV, Inc., and its affiliated corporations and subsidiaries (collectively, "CSAV"), intend to make this manual accurate and complete. However, CSAV makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product.
Installation Instructions RPMA1, -B1, -C1 LEGEND Tighten Fastener Pencil Mark Apretar elemento de fijación Marcar con lápiz Befestigungsteil festziehen Stiftmarkierung Apertar fixador Marcar com lápis Serrare il fissaggio Segno a matita Bevestiging vastdraaien Potloodmerkteken Serrez les fixations Marquage au crayon Loosen Fastener Drill Hole Aflojar elemento de fijación Perforar Befestigungsteil lösen Bohrloch Desapertar fixador Fazer furo Allentare il fissaggio Praticare un foro
RPMA1, -B1, -C1 Installation Instructions TOOLS REQUIRED FOR INSTALLATION 5/32" (Provided) PARTS Q (1) S (1) 5/32" T (8) U (4) V (4) R (4) A (4) 10-24 x 1/4" (NOT USED) D (4) M5 x 12mm G (4) M2.
Installation Instructions RPMA1, -B1, -C1 ASSEMBLY AND INSTALLATION 6. Installing Ceiling Plate and Disassembling RPMA1 Attaching Projector Security Legs 1. Pull RPMA1 bottom away from RPMA1 top. Attach the projector security legs (R) to the projector, using the correct size screws and washers for your specific projector.
RPMA1, -B1, -C1 2. Installation Instructions Remove the paper backing from the adhesive washers (V) and attach projector to RPMA1 bottom using adhesive washers (V) and thumbnuts (P) over the security legs (R). (See Figure 5) (P) x 4 (V) x 4 4 RPMA1 Bottom Security Legs (R) 5 Projector Figure 7 Attachment areas if using an optional SLB bracket. Figure 5 NOTE: An optional SLB bracket may be purchased and used 4. Move locking lever to "Locked" position. (See Figure 7) 5.
Installation Instructions RPMA1, -B1, -C1 3. Rough Alignment of RPMA1 1. Turn RPMA1 clockwise or counterclockwise until the front of the RPMA1 and projector is facing target. (See Figure 9) 1 Tighten YAW adjustment locking screw using a #2 Phillips screwdriver. PITCH Adjustment 1. Loosen PITCH adjustment locking screw using a #2 Phillips screwdriver. (See Figure 11) 2. Turn PITCH micro-adjustment screw right or left using a #2 Phillips screwdriver until image is properly aligned on target. 3.
RPMA1, -B1, -C1 Installation Instructions USA/International Europe Asia Pacific 8802-000254 2007 Chief Manufacturing www.chiefmfg.com 04/07 A P F A P F A 8401 Eagle Creek Parkway, Savage, MN 55378 800.582.6480 / 952.894.6280 877.894.6918 / 952.894.6918 Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands +31 (0)40 2668620 +31 (0)40 2668615 Room 30I, Block D, Lily YinDu International Building LuoGang, BuJi Town, Shenzhen, CHINA.