INSTALLATION INSTRUCTIONS IN-WALL ENCLOSURE Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutch Product Description French Product Description PAC502
PAC502 DISCLAIMER Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to change without notice or obligation of any kind.
Installation Instructions PAC502 DIMENSIONS .39 9.9 3.63 92.1 20X 5/16"-18 THREADS 12X 4X 1.75 44.5 .136 3.5 4X 4X 1.63 41.3 GROUNDING SCREWS 6X 3.94 100 20.00 508 .77 19.4 2X 12.00 304.8 NOTES: 3.85 97.9 30.00 762 2X 2.99 76 2X 2.20 55.9 .14 3.5 1" AND 2" TRADE SIZE PIPE CONDUIT 1.75 44.
PAC502 Installation Instructions TOOLS REQUIRED FOR INSTALLATION 3/16" PARTS Grounding screw and washer installed at factory Earthing symbol IEC 60417 No. 5019 affixed adjacent to grounding terminal.
Installation Instructions PAC502 INSTALLATION Frame Housing WARNING: IMPROPER INSTALLATION CAN RESULT IN DEATH OR SERIOUS PERSONAL INJURY! This accessory should be installed by qualified personnel. The exposed portion of the center wood stud must be removed and the resulting cavity completely framed with wood. The following steps are suggested. The actual procedure is dependent upon the specific installation.
PAC502 4. Installation Instructions Center PAC502 (A) in opening and insert into opening. Align front of box with front face of wall. (See Figure 3) (A) NOTE: The PAC502 has 1/2" total clearance between the two studs. The spacers allow side to side adjustment. 7. Drill eight 3/16" diameter pilot holes in horizontal framing at top and bottom mounting holes. (See Figure 5) 8.
Installation Instructions PAC502 Trim Kit (Optional) 1. Remove paper covering adhesive and affix three tape squares (K) to inside lower flange of each trim piece (G). (See Figure 7) 2. Orient trim pieces (G). (See Figure 7) 3. Remove paper covering adhesive back from tape squares (K) on trim and press trim (G) against inner wall of box. (See Figure 7) (G) x 4 3 1 (K) x 16 Figure 7 Installing Mount Assembly 1. Install mount assembly following instructions included with the mount. 2.
PAC502 Installation Instructions USA/International Chief Manufacturing, a products division of Milestone AV Technologies Europe Asia Pacific 8807-002019 Rev02 2010 Milestone AV Technologies, a Duchossois Group Company www.chiefmfg.com 11/10 A P F A P F A 8401 Eagle Creek Parkway, Savage, MN 55378 800.582.6480 / 952.894.6280 877.894.6918 / 952.894.6918 Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands +31 (0)40 2668620 +31 (0)40 2668615 Office No.
