Specifications

Installation Instructions DGI-42 and DGI-50
10
Adjust and Assemble Interior Mount
Adjust and assemble the interior mount as follows:
1. Adjust depth and elevation for your specific LFD
using the vertical (1 to 7) and horizontal (A to G)
hole patterns in the Deep Front Interior Mount (E-1).
For the Shallow Front Interior Mount (E-2), use
vertical holes 1 to 7 and horizontal holes A to D (see
Figure 10).
2. After selecting the appropriate hole patterns, fasten
the Front Interior Mount (E) to the Rear Interior
Mount (D) using the four ¼-20 x ½-inch bolts and
four ¼-20 nuts with attached tooth washers that are
supplied. Torque to 50 in-lbs (see Figure 11).
Figure 10. Front Interior Mount
Figure 11. Rear Interior Mount