Instruction Manual

FLR100 Installation Instructions
6
Attaching Speakers and Brackets
1. Attach speakers (not included) to speaker brackets (C)
following instructions included with speakers.
2. Loosely attach one 1/4-20 x 1/2" hex head cap screw (D),
one 1/4" lock washer (E) and one 1/4" flat washer (F) to top
of each of the speaker brackets (C). (See Figure 4)
3. Hang speaker brackets (with attached speakers) on the left
and right speaker extensions, and loosely attach bottom of
speaker brackets (C) to speaker extensions using one
1/4-20 x 1/2" hex head cap screw (D), one 1/4" lock washer
(E) and one1/4" flat washer (F) on each speaker extension.
(See Figure 4)
Figure 4
4. Push speakers into desired position by lifting slightly on
speakers to enable them to slide more easily.
5. Adjust and level speaker brackets (C) using lower slot. (See
Figure 4)
6. Tighten all four fasteners.
7. Turn knob (G) outward on both left and right speaker
brackets until the knob contacts the wall. This will allow
vertical leveling of the speakers.
(D) x 2
(F) x 2
2
(E) x 2
(A)
(C)
3
5
[left speaker end cap (A) shown]
Lower Slot