INSTALLATION INSTRUCTIONS Small Flat Panel Tilt Wall Mount Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutch Product Description French Product Description FPM Series
FPM Series Installation Instructions DISCLAIMER Milestone AV Technologies and its affiliated corporations and subsidiaries (collectively "Milestone"), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product.
Installation Instructions FPM Series LEGEND Tighten Fastener Pencil Mark Apretar elemento de fijación Marcar con lápiz Befestigungsteil festziehen Stiftmarkierung Apertar fixador Marcar com lápis Serrare il fissaggio Segno a matita Bevestiging vastdraaien Potloodmerkteken Serrez les fixations Marquage au crayon Loosen Fastener Drill Hole Aflojar elemento de fijación Perforar Befestigungsteil lösen Bohrloch Desapertar fixador Fazer furo Allentare il fissaggio Praticare un foro Beves
FPM Series Installation Instructions INSTALLATION The FPM may be installed on either a single 2" x 4" wood stud, or on drywall (1/2" minimum thickness). The FPM allows a tilt range from 5° up to 18° down. 2 x2 NOTE: The latching flag may be moved, if necessary. (See 4 x2 Figure 1) 5 (D) x 2 Flag (A) (C) Figure 2 Flag may be moved Install Mount to Drywall WARNING: Drywall must be a minimum thickness of 1/2" Figure 1 and a maximum thickness of 5/8".
Installation Instructions 3. FPM Series Drill 3/8" anchor holes. Ensure holes are straight and completely through drywall. (See Figure 3) (A) 4 2 (B) x 4 x4 3 (B) Anchor x 4 screws 8 5 x4 (C) x 4 Figure 3 4. Gently tap anchor (B) into anchor hole. Anchor barbs should be fully engaged in drywall (See Figure 4). Anchor not collapsed Drywall Anchor collapsed Figure 5 Install Display to Mount NOTE: Proper interface must be attached to display.
FPM Series Installation Instructions 2. Lift and maneuver display such that all mounting buttons fit into openings on FPM (A). (See Figure 7) 3. Lower display firmly into place. Ensure each mounting button has fully seated in the opening (See Figure 7) 4. Close latching flag by rotating flag counterclockwise on FPM (A). (See Figure 7) 10° Tilt Down Latching flag 4 (A) 2 3 Display 1 2 Figure 8 Figure 7 Adjusting Tilt 1. Loosen adjusting screws on each side of display (See Figure 8). 2.
Installation Instructions FPM Series 7
FPM Series Installation Instructions USA/International Europe Chief Manufacturing, a products division of Milestone AV Technologies 8803-000034 RevD 2011 Milestone AV Technologies, a Duchossois Group Company www.chiefmfg.com 09/11 Asia Pacific A P F A P F A 8401 Eagle Creek Parkway, Savage, MN 55378 800.582.6480 / 952.894.6280 877.894.6918 / 952.894.6918 Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands +31 (0)40 2668620 +31 (0)40 2668615 Office No.