INSTALLATION INSTRUCTIONS LCM2X2 LCM3X3 LCM3X2 Ceiling Mounted Video Walls Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutch Product Description French Product Description LCM Video Wall Series
LCM Video Wall Series Installation Instructions DISCLAIMER Milestone AV Technologies and its affiliated corporations and subsidiaries (collectively "Milestone"), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product.
Installation Instructions LCM Video Wall Series LEGEND Tighten Fastener Pencil Mark Apretar elemento de fijación Marcar con lápiz Befestigungsteil festziehen Stiftmarkierung Apertar fixador Marcar com lápis Serrare il fissaggio Segno a matita Bevestiging vastdraaien Potloodmerkteken Serrez les fixations Marquage au crayon Loosen Fastener Drill Hole Aflojar elemento de fijación Perforar Befestigungsteil lösen Bohrloch Desapertar fixador Fazer furo Allentare il fissaggio Praticare un
LCM Video Wall Series Installation Instructions TOOLS REQUIRED FOR INSTALLATION 1/2" #2 1/2" nut driver 5/32" (included) 1/2" 7/32" (included) PARTS [Quantities of parts noted as: LCM2X2/LCM3X2/LCM3X3] A (16/24/36) M6 x 12mm B (16/24/36) M6 x 16mm Hardware bag (Letters correspond to letters on bag) F (16/24/36) M8 x 12mm G (16/24/36) M8 x 16mm L (4/6/9) [Interface bracket-right] C (16/24/36) D (16/24/36) E (16/24/36) 1/4" M6 x 30mm .750x.344x.
Installation Instructions LCM Video Wall Series INSTALLATION 7. IMPORTANT ! : Refer to Dimensions section at end of Attaching Array Offset to Installed Column instructions to find specific LCM video wall dimension requirements BEFORE proceeding with installation. NOTE: If the column attached to the ceiling plate is a 1-1/2" Repeat for remaining array offset (N). NPT column, the UL Listed CPA261 adapter accessory (KK) must first be installed following instructions included with the accessory.
LCM Video Wall Series Installation Instructions Installing Interface Brackets to Displays 1. Place displays face down on a soft, non-abrasive surface. CAUTION: Using screws of improper length may damage your display! Proper screws will have adequate thread engagement without contacting bottom of display mounting holes. IMPORTANT ! : Screen width information is contained in the Dimension drawings at the end of these instructions. 4.
Installation Instructions LCM Video Wall Series Adding Array Heads to Columns 2.44 61.9 DISTANCE FROM BOTTOM OF COUPLING TO TOP OF COLUMN 2X2 / 3X2 Screen Arrangement 48.00 1219.2 COLUMN LENGTH APPROXIMATE C/L OF BOTTOM SCREEN APPROXIMATE ONE SCREEN HEIGHT 3.84 97.6 DIMENSIONS: INCHES [MILLIMETERS] 3X3 Screen Arrangement 2.44 61.9 DISTANCE FROM BOTTOM OF COUPLING TO TOP OF PERFORATED COLUMN APPROXIMATE ONE SCREEN HEIGHT 72.00 1828.
LCM Video Wall Series Installation Instructions 1. Lay columns (GG or JJ) on floor and carefully place display next to columns. (See Figure 4) and (See Figure 5) 2. Mark center of display (diamond on interface brackets) onto both columns. (See Figure 5) 3. Measure one screen height up on the columns from the first mark.
Installation Instructions LCM Video Wall Series Attaching Column Assembly to Array Offset 1. 2. Arrange column assembly so that the open side of the array head (X) is facing the back of the video wall. (See Figure 9) Loosely fasten column assembly to array offset (N) using four 5/16" x 1" hex head self-tapping screws (S), four 5/16" split washers (T), and four 5/16" washers (U). (See Figure 9) 3. Slide top T-slot nuts (AA) with attached lock nuts (DD) down into top openings on array head (X).
LCM Video Wall Series Installation Instructions Adding Displays to Mounting Rails 2 WARNING: Exceeding the weight capacity can result in 3 4 serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the combined weight of all components located within the mounting system of the LCM Series model does not exceed maximum weights listed in table below. MODEL Max Weight Allowed for EACH Display Max Weight Capacity of Mounting System LCM2X2U 125 lbs 500 lbs (56.
Installation Instructions LCM Video Wall Series Adding Back Cover CAUTION: ALWAYS keep a small distance between 1. screens when making adjustments! Damage to screens possible if placed too close together. Add back cover (Y) to array head (X) by inserting four corner tabs into four holes on back of array head. (See Figure 17) 10. Move displays so that screens are flush and level with each other. 11. Use upper knob on back of interface brackets (L and M) to adjust the height of each display.
LCM Video Wall Series Installation Instructions DIMENSIONS - LCM2X2 LCM2X2 72.83 1850.0 8.50 215.9 1.41 35.
Installation Instructions LCM Video Wall Series DIMENSIONS - LCM2X2 (continued) 14.50 368.3 LCM2X2 A 9.05 229.8 C/L OF SCREENS CENTER OF GRAVITY OF SCREENS SHOULD BE AS CLOSE IN LINE WITH THE UPPER COLUMN AS POSSIBLE COLUMNS SHOULD BE SPACED AT CENTER OR SLIGHTLY TO THE OUTSIDE OF CENTER (AS SHOWN) MAINTAIN SLIGHT GAP BETWEEN SCREENS SHOWN WITH SIMULATED 42" SCREENS 0.13 3.
LCM Video Wall Series Installation Instructions DIMENSIONS - LCM3X2 LCM3X2 108.83 2764.4 6.80 172.
Installation Instructions LCM Video Wall Series DIMENSIONS - LCM3X2 (continued) LCM3X2 14.50 368.3 A 9.05 229.
LCM Video Wall Series Installation Instructions DIMENSIONS - LCM3X2 (continued) LCM3X2 0.13 3.2 DIMENSIONS - LCM3X3 LCM3X3 108.83 2764.
Installation Instructions LCM Video Wall Series DIMENSIONS - LCM3X3 (continued) 14.50 368.3 LCM3X3 A 9.05 229.
LCM Video Wall Series Installation Instructions DIMENSIONS - LCM3X3 (continued) LCM3X3 6.80 172.7 0.13 3.
Installation Instructions LCM Video Wall Series 19
LCM Video Wall Series Installation Instructions USA/International Europe Chief Manufacturing, a products division of Milestone AV Technologies 8800-002283 Rev01 2013 Milestone AV Technologies, a Duchossois Group Company www.chiefmfg.com 01/13 Asia Pacific A P F A P F A 6436 City West Parkway, Eden Prairie, MN 55344 800.582.6480 / 952.225.6000 877.894.6918 / 952.894.6918 Franklinstraat 14, 6003 DK Weert, Netherlands +31 (0) 495 580 852 +31 (0) 495 580 845 Office No.
