User's Manual

Installation Instructions HFSTS
7
5. Connect cord to bottom of column-mounted tablet. (See
Figure 4)
6. Install column cover (B) onto column (A) making sure
keyholes are onto screws and cable is routed through the
bottom gap on cover. (See Figure 4)
7. Tighten all screws (F) to secure cover (B) to column (A).
(See Figure 4)
Figure 4
Cable Management
1. Loosen screws (E) holding cover (B) to column (A) and
remove cover (B). (See Figure 5)
2. Route component cable(s) using middle and lower
openings on cover (B). (See Figure 5)
3. Reinstall cover (B) and tighten screws (E) to secure cover
(B) to column (A). (See Figure 5)
Figure 5
Bolt to Floor (Optional)
The HFSTS mount may be bolted to the floor for increased
security or stability. Hardware is NOT provided for this
installation.
IMPORTANT ! : Base plates (D) must be attached to
column (A) and bolt plate (C) before being bolted to floor.
1. Use base plates (D) as a template to mark holes on floor at
desired mounting location.
2. Drill holes at marked locations according to instructions of
hardware being used for installation. (See Figure 6)
3. Use hardware (not included) to secure base plates (D) to
floor. (See Figure 6)
Figure 6
5
6
6
6
7
(E) x 6
(tighten)
(A)
(B)
1
1
3
3
2
2
component cable
1
2
3
x 4
(D) x 2