Installation instructions

Installation Instructions IR10
5
4. Using a slotted screwdriver, connect power and signal wires
to the IR to Dry Control accessory (A). (See Figure 2)
Figure 2
The remote control has a range of 20-30ft (6-9m), and is
powered by 2 AAA batteries that are accessed from the back of
the remote.
The following table and illustration identify mount functionality
and response by button on the remote control(s).
IMPORTANT ! : Power must be provided to device and IR
receiver must be installed in order to access extended IR10
programming options.
Normal Operating Mode
Figure 3
KEY CONTROL OUTPUT
A COMMON
B PRESET 1
C DOWN
D UP
E GROUND
F 12V or 24V Power supply
(A) X 1
(A) X 1
(A)
(B)
(C)
(D)
(E)
(F)
COM
C3
C2
C1
12V
KEY FUNCTION REQUIRED ACTION
1 NOT USED N/A
2 NOT USED N/A
3 CLOSE CONTACT #1 PRESS AND HOLD
4 NOT USED N/A
5 NOT USED N/A
6 NOT USED N/A
7 CLOSE CONTACT #2 PRESS AND HOLD
8 CLOSE CONTACT #3 PRESS AND HOLD
9 NOT USED N/A
10 NOT USED N/A
7
1
4
5
2
8
10
9
3
6