INSTALLATION INSTRUCTIONS Medium Flat Panel In-Wall Swing Arm Mount JWDIW Series
JWDIW Series Installation Instructions DISCLAIMER Milestone AV Technologies, Inc., and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product.
Installation Instructions JWDIW Series TOOLS REQUIRED FOR INSTALLATION AND PARTS 3/16" (Included) 7/32" (Included) B (4) A (1) I/M x1 Interface Bracket Kit J (4) 8-32 x 1/2" H (2) G (2) E (4) 1/4" D (4) 5/16" C (4) 5/16-18 x 5/8" F (1) K (4) (including hardware) x1 R (4) L (12) M (4) N (2) 08 x 1/2" P (1) 3/16" Q (1) 7/32"" 3
JWDIW Series Installation Instructions Installation 5. The following procedure assumes that a Chief Listed Model MAC501 In-Wall accessory has previously been installed following the installation instructions provided by the manufacturer. If a MAC501 is not installed or there are any other questions regarding the installation of this accessory, immediately contact a Chief Customer Service representative. Align four mounting holes in swing arm mounting bracket with four mounting holes in MAC501.
Installation Instructions JWDIW Series 5. Display Installation Route cables and wires to display. NOTE: If the display being installed has a 100x100 VESA mounting pattern, no interface bracket is required and the display can be mounted directly to the Centris cup as outlined below. NOTE: If the display being installed requires an interface 2 bracket, refer to the interface bracket installation instructions.
JWDIW Series Installation Instructions Optional Trim Installation 1. Remove paper covering adhesive from tape squares (L) and affix three tape squares to inside lower flange of each trim piece (B). (See Figure 7) 2. Orient trim pieces (B). 3. Remove paper covering adhesive back from tape squares (L) on trim and press trim (B) against inner wall of box. (See Figure 7) 2 (See Figure 7) 1 2 3 Figure 8 (B) x 4 (L) x 12 DISPLAY ROLL, PITCH, YAW Tension 1.
Installation Instructions JWDIW Series 7
JWDIW Series Installation Instructions USA/International Chief Manufacturing, a products division of Milestone AV Technologies 8805-000241 RevC 2009 Milestone AV Technologies, a Duchossois Group Company www.chiefmfg.com 11/09 Europe Asia Pacific A P F A P F A 8401 Eagle Creek Parkway, Savage, MN 55378 800.582.6480 / 952.894.6280 877.894.6918 / 952.894.6918 Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands +31 (0)40 2668620 +31 (0)40 2668615 Office No.
