Installation instructions

Installation Instructions K1 Series
15
Figure 21
3. Route cables through cable management channels. (See
Figure 21)
IMPORTANT ! : Be sure to leave enough slack in the
cables near display and arm joint to allow for full arm
articulation!
4. Close cable management covers on monitor arm. (See
Figure 21)
5. Repeat Steps 1-4 for lower arm.
Display Removal
WARNING: Only remove display from mount when the
display can be lifted up from the mount! DO NOT remove
display unless the display is in the upright position! (See
Figure 22)
1. Make sure display is in the upright position.
2. Remove quick release faceplate from mount by pressing
quick release tab and sliding faceplate off mount. (See
Figure 22)
Figure 22
2
2
4
4
3
3
cable (typical)
quick release tab
2