User Manual

Milestone AV Tec hnol ogie s, and its affiliated corpo rat ions and subsidiaries (collectiv el y, "Miles tone"), intend to mak e th is ma nual accurate an d compl ete. However, Mi lestone mak es
no claim that the information con tained herein co vers all deta ils, con ditions or variations, nor does it provide for every possible conti ngency in connection with the i nstallation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty , expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility fo r accuracy, completeness or suffici ency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
6436 City West Parkway, Eden Prairie, MN 55344
• P: 800.582.6480 / 952.225.6000 • F:877.894.6918 / 952.894.6918
8800-0 02 20 3 R ev 00
©2012 Mil estone AV Technologies,
a Ducho ssois Group Comp any
07/12
INSTALLATION INSTRUCTIONS
The LCS-W1-12/-20/-28/-36 Lacer Strips Kits are designed for use
as cable management in Chief® Series NW1 racks.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: Failure to read, thoroughly understand, and follow
all instructions can result in serious personal injury, damage to
equipment, or voiding of factory warranty! It is the installer’s
responsibility to make sure all components are properly
assembled and installed using the instructions provided.
TOOLS FOR I NSTALLATION / PARTS
INCLUDED
INSTALLATION
NOTE: The lace r stri p (A) may be placed on the stud s on eit her the
left or right side of back inside wall.
1. Place nylon spac ers (B) over studs on back inside wall of NW1
rack. (See Figure 1)
2. Place lacer strip (A) over nylon spacers (B).
3. Fasten lacer strip in place using 1/4-20 nuts (C) over studs on
back inside wall of NW1 rack.
Figure 1
Chief® is a registered trademark of M ilestone AV
Technologies. All rights reserved.
QUANTITIES
LCS-W1- 12 LCS-W1-20
LCS-W1- 28
LCS-W1- 36
A
[Lacer stri p]
B
[.61x.28x.50]
C
1/4-20
1
3
3
1
(Appearance
varies
per model)
3
3
1
4
4
4
4
1
7/16"
(B)
(A)
1
(C)
Stud
(Some par ts removed to show back wall of NW1 rack clearly.)
LCS-W1-12 / LCS-W1-20 / LCS-W1-28 / LCS-W1-36 Lacer Strips Kits

Summary of content (1 pages)