INSTALLATION INSTRUCTIONS Fixed Wall Racks Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutch Product Description French Product Description NW2F8-12
NW2F8-12 Installation Instructions DISCLAIMER Milestone AV Technologies and its affiliated corporations and subsidiaries (collectively "Milestone"), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product.
Installation Instructions NW2F8-12 DIMENSIONS NW2F818 NW2F1218 DIMENSIONS: INCHES [MILLIMETERS] 3
NW2F8-12 Installation Instructions TOOLS REQUIRED FOR INSTALLATION wood stud - 7/32" concrete - 5/16" steel stud - 1/2" 5/16" - security (included) 7/16" PARTS (Model NW2F1218 shown for Parts A, B, C) B (1) [Door] C (1) [Mounting plate] A (1) [Wall rack] E (4) [Anchor] D (4) 5/16" F (4) 5/16 x 2-1/2" G (4) 1/4-20 x 1-3/4" H (4) 1/4" K (2) 10-32 x 1/2" L (2) 1/4-20 J (4) 1/4-20 snap toggle M (1) 5/32" (security) 4 N (1) [Rack wire]
Installation Instructions NW2F8-12 SITE REQUIREMENTS (NW2F8-18 and NW2F12-18 Models) - Steel Stud Structure WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! The figure below identifies the minimum requirements for installation of display mounts onto a steel stud structure. If the structure or its components do not meet these requirements contact the mount manufacturer for specific instructions before attempting installation.
NW2F8-12 Installation Instructions INTRODUCTION The NW2 wall racks have been designed to be mounted onto either a 2" x 4" wood stud (16" on center), concrete, or steel stud wall.
Installation Instructions NW2F8-12 1. Using the mounting plate (C) as a template, mark the wall at the top mounting slots. (See Figure 3) 2. Drill one 5/16" pilot hole at both marks made in Step 1. (See Figure 3) 3. Install an anchor (E) into each pilot hole using a hammer, making sure that the anchor is flush with the wall.
NW2F8-12 3. Installation Instructions Hold metal channel on anchor (J) flat alongside plastic straps and slide channel through hole. (See Figure 5) Drywall Plastic straps 8. Place mounting plate (C) over anchors and align top mounting holes in mounting plate with holes in anchors. 9. Insert 1/4-20 x 1-3/4" Phillips pan head screws (G) through 1/4" washer (H), corresponding mounting hole on mounting plate and into anchor (J) and tighten until flush against mounting plate.
Installation Instructions NW2F8-12 Attaching Door NOTE: The door may be attached on either the left or right of the rack. 1. Rotate two spring handles (one at bottom and one at top) on inside of door. (See Figure 9) 4. Add one end of rack wire (N) to grounding stud at bottom of door. (See Figure ) 5. Tighten 1/4-20 nut (L) onto grounding stud. (See Figure ) 6. Place opposite end of rack wire to grounding stud on floor of rack. (See Figure ) 7.
NW2F8-12 Installation Instructions Completing Installation 1. Hang rack over top rail of mounting plate. (See Figure 13) 2. Fasten rack from below to mounting plate using two 10-32 x 1/2" security buttonhead screws (K). (See Figure 13) (front view of rack) (inside view of door) Location of grounding lugs Location of grounding lugs Grounding screw and nut installed at factory Earthing symbol IEC 60417 No. 5019 affixed adjacent to grounding terminal.
Installation Instructions NW2F8-12 NOTE: Continue placing items into the rack, moving from the bottom upward. CAUTION: The top of the unit should not be used as a shelf. CAUTION: DISTRIBUTE LOAD CORRECTLY! Load rack with 2/3 total weight of components in the lower half of rack. Loading rack incorrectly may result in instability causing possible injury and/or damage to components.
NW2F8-12 Installation Instructions USA/International Europe Chief Manufacturing, a products division of Milestone AV Technologies 8821-002035 Rev00 2011 Milestone AV Technologies, a Duchossois Group Company www.chiefmfg.com 05/11 Asia Pacific A P F A P F A 8401 Eagle Creek Parkway, Savage, MN 55378 800.582.6480 / 952.894.6280 877.894.6918 / 952.894.6918 Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands +31 (0)40 2668620 +31 (0)40 2668615 Office No.