INSTALLATION INSTRUCTIONS Instrucciones de instalación Installationsanleitung Instruções de Instalação Istruzioni di installazione Installatie-instructies Instructions d´installation Large Flat Panel Tilt Wall Mount with Integrated CPU Enclosure Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutch Product Description French Product Description PWC-2000
PWC-2000 Installation Instructions DISCLAIMER CSAV, Inc., and its affiliated corporations and subsidiaries (collectively, "CSAV"), intend to make this manual accurate and complete. However, CSAV makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to change without notice or obligation of any kind.
Installation Instructions PWC-2000 tragen kann. Andernfalls muss die Wand verstärkt werden, bevor die Komponente angebracht wird. WARNUNG: Wenn das zulässige Gewicht überschritten wird, kann dies zu schweren Körperverletzungen oder Schäden an den Geräten führen! Der Monteur ist dafür verantwortlich, dass das kombinierte Gewicht aller Komponenten, die am Modell PWC-2000 befestigt sind, nicht mehr als 90 kg beträgt.
PWC-2000 maal het gezamenlijke gewicht van alle apparatuur kan dragen. Zonodig dient u de structuur vóór de montage van de component te versterken. WAARSCHUWING: Overschrijding van het draagvermogen kan de oorzaak zijn van ernstig persoonlijk letsel en beschadiging van de apparatuur! Degene die het product installeert is ervoor verantwoordelijk dat het totale gewicht van alle componenten die aan de PWC-2000 worden bevestigd een gewicht van 90 kg niet overschrijdt.
Installation Instructions PWC-2000 LEGEND Tighten Fastener Pencil Mark Apretar elemento de fijación Marcar con lápiz Befestigungsteil festziehen Stiftmarkierung Apertar fixador Marcar com lápis Serrare il fissaggio Segno a matita Bevestiging vastdraaien Potloodmerkteken Serrez les fixations Marquage au crayon Loosen Fastener Drill Hole Aflojar elemento de fijación Perforar Befestigungsteil lösen Bohrloch Desapertar fixador Fazer furo Allentare il fissaggio Praticare un foro Bevesti
PWC-2000 Installation Instructions TOOLS REQUIRED FOR INSTALLATION 7/32" (5.5mm) 1/2" (12.7mm) PARTS B (2) 1/4"-20 x 1/2" (6.4mm-20 x 12.7mm) E (1) 1" x 6’ (25.4mm x 1.83m) C (4) 1/4"-20 x 1/2" (6.4mm-20 x 12.7mm) F (1) 5/32" (6.4mm x 4.0mm) A (1) D (2) 1/4"-20 (6.
Installation Instructions PWC-2000 INSTALLATION NOTE: Lower front plate attach screws may remain installed. MOUNT INSTALLATION 1 WARNING: Failure to provide adequate structural strength x2 for this component can result in serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the structure to which this component is attached can support five times the combined weight of all equipment. Reinforce the structure as required before installing the component. 1.
PWC-2000 4. Installation Instructions Carefully slide CPU between strap (E) and rear surface of side plates (See Figure 5). Ensure the following: • DISPLAY INSTALLATION Both loops of strap (E) are in front of the CPU; do not wrap strap (E) around back of CPU. CPU is positioned so that cooling vents are not obstructed.
Installation Instructions 4. PWC-2000 Rotate Q-Latch to the CLOSED position (See Figure 9). NOTE: If Q-Latch does not fully close, ensure mounting buttons are fully seated in the button openings. TILT LOCK If desired, the display may be locked at 0°, 5°, or 10°. NOTE: A positive stop exists at 15° without the use of tilt lock NOTE: OPTIONAL: A hole is provided in both the Q-Latch and the front plate to accommodate the insertion of a padlock or similar locking device. screws. 1.
PWC-2000 10 Installation Instructions
Installation Instructions PWC-2000 11
PWC-2000 Installation Instructions USA/International Europe Asia Pacific 8804-000317 RevA ©2007 Chief Manufacturing www.chiefmfg.com 10/07 A P F A P F A 8401 Eagle Creek Parkway, Savage, MN 55378 800.582.6480 / 952.894.6280 877.894.6918 / 952.894.6918 Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands 31 (0)20 5708923 31 (0)20 5708989 Room 30I, Block D, Lily YinDu International Building LuoGang, BuJi Town, Shenzhen, CHINA.
