Owner's Manual

Installation Instructions SYSAU
9
INSTALLING THE SUSPENDED CEILING PLATE
NOTE: The SYSAU has been designed to be mounted above
or flush with a suspended ceiling secured by a
WireVice system. The method used may be
determined by the existing ceiling system.
1. Remove outlet plate from suspended ceiling plate assembly
(R) if electrical outlet will be installed (See Figure 6), and
install UL Listed Raco 256, 232 or equivalent UL Listed
electrical box (not included) to SYSAU outlet plate following
instructions included with electrical box.
Figure 6
2. Determine exact location of column. Mark location on lower
(finished) side of ceiling tile. (See Figure 7)
• Flush with Suspended Ceiling
Mark location on ceiling tile framework.
• Install on Top of Existing Ceiling Tile
Mark location on lower (finished) side of ceiling tile.
Figure 7
Be sure to consider the following items when determining
column location:
• Dimensional offset of display/projector relative to
column (due to mount and/or interface).
• For Projectors: Any recommended dimensions of
projector relative to target. (See installation instructions
included with the projector.)
3. Remove affected ceiling tile and any adjacent tiles required
for access.
4. Installing on Top of Existing Ceiling Tile only: Press
center tip of ceiling tile cutter (BB) into finished side of
ceiling tile at marked location. Cut extension column hole
through tile using back and forth motion.
5. Installing on Top of Existing Ceiling Tile only: Reinstall
ceiling tile with extension column hole. Ensure tile is
oriented for proper location of hole.
6. Installing on Top of Existing Ceiling Tile only: Install
suspended ceiling plate assembly (R) on top of ceiling tile
so that end brackets engage primary (1-1/2" (38mm) high)
rails of ceiling framework. (See Figure 8)
Figure 8
7. Flush with Suspended Ceiling only: Install suspended
ceiling plate assembly (R) on top of ceiling framework rails
so that end brackets engage primary (1-1/2" (38mm) high)
rails of ceiling framework. (See Figure 8)
8. Loosen two wing nuts at each end of ceiling plate assembly.
(See Figure 9)
9. Raise or lower adjustable bracket, as necessary, at each
end of the ceiling plate assembly.
10. Tighten wing nuts on adjustable bracket at each end of the
ceiling plate assembly. (See Figure 9)
Figure 9
1
Electrical plate
2
6
= 1.5" (38mm)
(R)
7
8
10
9
x 4
9
9