Installation instructions

WP2XS, WP2XUS Installation Instructions

Projector Installation (WP2XUS Models Only)

WARNING: Exceeding the weight capacity can result in

serious personal injury or damage to equipment! It is the

installer’s responsibility to make sure the weight of the

projector does not exceed 25 lbs (11.3 kg).

1. Assemble and attach SSBU (W, X and Y) to projector

following instructions included with SSBU.

NOTE: SSBU bracket may also be installed using the optional

All-Points Security Kit (L-P).

WARNING: IMPROPER INSTALLATION CAN LEAD TO

PROJECTOR FALLING RESULTING IN SERIOUS

PERSONAL INJURY OR DAMAGE TO EQUIPMENT.

Ensure that mounting slots in mount base slide under thumb

screws and that screws are seated in the back of slots.

2. Orient projector with attached SSBU bracket so that front of

projector faces wall. (See Figure 11)

3. Lift projector so that screws with thumb nuts (V) in SSBU

are aligned with mounting slots in projector arm base. (See

Figure 11)

4. Slide projector with SSBU bracket onto mounting slots in

projector arm base until screws are seated against the back

of mounting slots. (See Figure 11)

5. Turn thumb nuts until tight to secure projector to projector

arm. (See Figure 12)

6. Tighten the M5x35mm button head cap screw (H) on the

wall plate (E). (See Figure 12)

NOTE: Proceed to Adjustments section to continue

installation.

Figure 11

(A)

(W, X, Y)

Front of

projector

Mounting

slots

Mounting

slots

Figure 12

(H) x 1

(A)

(E)

(V)